Audio Distortion - One or More Speakers

Step	Action	Yes	No
Schematic Reference: Radio/Audio System Schematics DEFINITION: This table is used for vehicles equipped with a radio amplifier.
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2	Turn ON the ignition, with the engine OFF. Turn ON the radio. Adjust the fade and balance controls to mid range. Insert the tape or CD from the J 39916-A CD and Cassette Diagnostic Audio Kit. See Special Tools . Can audio distortion be heard from any speaker?	Go to Step 3	Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems
3	Test the appropriate radio speaker output circuits between the radio and the radio amplifier for an open or high resistance. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 6	Go to Step 4
4	Inspect for poor connections at the harness connector of the appropriate speaker. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 6	Go to Step 5
5	Replace the speaker. Refer to Speaker Replacement - Rear or to Speaker Replacement - Front Lower . Did you complete the replacement?	Go to Step 6	-
6	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 2