LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Vibe GT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Mechanical - 1.8L (LV6)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Positive Crankcase Ventilation (PCV) Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: PCV Valve, Hose Clamp And Valve Hose
    GM607626Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Component Fastener Tightening Notice in Cautions and Notices.
  1. Install the PCV valve (1) into the cylinder head.

    Tighten:  Tighten the PCV valve to 27 N.m (13 lb ft).

  2. Connect the PCV valve hose (3) to the PCV valve (1).
  3. Secure the PCV valve hose with one clamp (2).
scientia non olet · About LEMON Manuals