LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2004 >> Vibe GT >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Mechanical - 1.8L (LV6)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Crankshaft Front Oil Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Installing Oil Seal
    GM234233Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the new crankshaft front oil seal with Chassis Grease GM P/N 1051344 (Canadian P/N 993037) or equivalent.
  2. Using a hammer and an appropriate driver, lightly tap the crankshaft front oil seal into place.
    IMPORTANT: Tap the oil seal in until its surface is flush with the crankshaft front oil seal retainer edge.
  3. Install the crankshaft pulley. Refer to Crankshaft Pulley Replacement .
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Connect the negative battery cable.

    Tighten:  Tighten the battery cable bolt to 15 N.m (11 lb ft).

  5. Start the engine.
scientia non olet · About LEMON Manuals