LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 1995 >> Firebird Formula, 2D Convertible, Standard >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> Engine Mechanical 5.7L V8 - VIN [P] >> Removal & Installation >> Cylinder Head >> Installation

Cylinder Head: Installation

  1. Clean cylinder head bolt holes and threads. Coat steel-type head gaskets with sealer. DO NOT coat composition-type head gaskets with sealer. Install head gasket onto cylinder block. Install cylinder head. Coat head bolts with Sealing Compound (1052080).
  2. Tighten bolts in 3 steps in sequence. See Fig 1. Tighten bolts to specification. See TORQUE SPECIFICATIONS . To complete installation, reverse removal procedure.
Fig 1: Cylinder Head Bolt Tightening Sequence
G94H33156Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals