Crankshaft Balancer Pulley Assembly & Hub: Installation

NOTE: If balancer assembly is replaced, new balance weights of the same size must be installed on the new balancer assembly in the same hole locations as the old balancer assembly.

The crankshaft hub (45) can be installed by a different procedure if the engine should accidentally be cranked over after match marking the hub and engine front cover assembly.:

Set number 1 piston assembly to top dead center.
Install crankshaft hub (45) with cast arrow on hub in the 12 o'clock position.

Install crankshaft hub (45) using Installer (J 39046). Install crankshaft hub washer and bolt/screw. Install crankshaft balancer assembly (42) and bolts/screws (46). See Figure. Tighten fasteners to specification. See TORQUE SPECIFICATIONS .