Test 12A - Passenger Squib Term Shorted To Battery
NOTE:
Perform TEST VER-1A - VERIFICATION TEST
after all repairs. Each time a connector is disconnected, inspect it to ensure it is in good condition. Always focus on circuit being tested. Dirt, water and corrosion, are most common problems in connectors. Due to manufacturer changes in wire colors, use terminal identification whenever possible.
Turn ignition off and wait 2 minutes before proceeding. Disconnect ACM 4-pin connector. Disconnect passenger-side air bag module connector. Turn ignition on (engine off). Using a voltmeter, check voltage at ACM 4-pin connector terminals No. 1 (Light Green/Yellow wire; Dark Green/Yellow wire on Sebring Convertible) and terminal No. 2 (Red/White wire; Black/Yellow wire on Sebring Convertible). If voltage is more than 0.5 volts in either circuit, repair short to voltage in appropriate circuit. If voltage is less than 0.5 volts, replace ACM.