LEMON Manuals: Even more car manuals for everyone
Home >> Oldsmobile >> 1992 >> Toronado Base >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel - Electronic >> Testing >> Tachometer Display Missing/Intermittent Test

Tachometer Display Missing/Intermittent Test

  1. With ignition switch in RUN position, enter self-diagnostics. See ENTERING IPC SELF-DIAGNOSTICS  under ON-VEHICLE DIAGNOSTICS. Select IPC INPUT II09. Operate tachometer switch.
  2. With tachometer switch released, display should indicate HI. With tachometer switch depressed, display should indicate LO. If display indicates LO with tachometer switch released, go to next step. If display indicates HI with tachometer switch depressed, go to step 4).
  3. Remove left tachometer switch assembly. See LEFT TACHOMETER SWITCH  under REMOVAL & INSTALLATION. If display now indicates HI, replace left tachometer switch assembly. If display indicates LO, check White wire from left tachometer switch connector terminal B11 for a short to ground. If wire is okay, replace IPC. See INSTRUMENT PANEL CLUSTER (IPC)  under REMOVAL & INSTALLATION.
  4. If display indicates HI with tachometer switch depressed, remove left tachometer switch assembly. See LEFT TACHOMETER SWITCH  under REMOVAL & INSTALLATION. Connect a fused jumper wire between left tachometer switch assembly terminals B11 (White wire) and B7 (Black wire).
  5. If display indicates HI, go to next step. If display indicates LO, check left tachometer switch assembly connector terminals. If terminals are okay, replace left tachometer switch assembly.
  6. Connect a fused jumper wire between left tachometer switch assembly terminal B11 (White wire) and ground. If display indicates HI, go to next step. If display indicates LO, repair Black wire from terminal B7.
  7. Remove IPC. See INSTRUMENT PANEL CLUSTER (IPC)  under REMOVAL & INSTALLATION. Connect an ohmmeter between IPC connector terminal D13 (White wire) and left tachometer switch connector assembly terminal B11 (White wire). If zero ohms are present, replace IPC after checking for good terminal contact. If high resistance is present, check and repair White wire between terminals B11 and D13 for an open circuit.
scientia non olet · About LEMON Manuals