Component Inspection (EOP sensor)
WARNING: This page is about a different variant/trim than selected.
- CHECK EOP SENSOR
- Turn ignition switch OFF.
- Disconnect EOP sensor harness connector.
- Check resistance between EOP sensor connector terminals.
+
-
Condition
Resistance (kOhm)
EOP sensor
Terminal
1
2
None
4 kOhm- 10 kOhm
3
2 kOhm- 8 kOhm
2
1
4 kOhm- 10 kOhm
3
1 kOhm- 3 kOhm
3
1
2 kOhm- 8 kOhm
2
1 kOhm- 3 kOhm
Is the inspection result normal?
YES
INSPECTION END.
NO
Replace EOP sensor. Refer to Exploded View .