LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Control System (DTC/Circuit Diagnosis) (5.6L) (4 Of 6)) >> DTC/Circuit Diagnosis >> DTC P0345: CMP Sensor >> Component Inspection (Camshaft Position Sensor)

Component Inspection (Camshaft Position Sensor)

WARNING: This page is about a different variant/trim than selected.
  1. CHECK CAMSHAFT POSITION SENSOR-I 
    1. Turn ignition switch OFF.
    2. Loosen the fixing bolt of the sensor.
    3. Disconnect camshaft position sensor harness connector.
    4. Remove the sensor.
    5. Visually check the sensor for chipping.
      GNSJMBIA0065Z-065Courtesy of NISSAN NORTH AMERICA, INC.

    Is the inspection result normal?

    YES

    GO TO 2.

    NO

    Replace malfunctioning camshaft position sensor.

  2. CHECK CAMSHAFT POSITION SENSOR-II 

    Check resistance camshaft position sensor terminals as per the following.

    Terminals (Polarity)

    Resistance

    1 (+) - 2 (-)

    Except 0 or INF.Ohm [at 25 deg.C (77 deg.F)]

    1 (+) - 3 (-)

    2 (+) - 3 (-)

    Is the inspection result normal?

    YES

    INSPECTION END

    NO

    Replace malfunctioning camshaft position sensor. Refer to Exploded View .

scientia non olet · About LEMON Manuals