LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Control System (DTC/Circuit Diagnosis) (5.6L) (4 Of 6)) >> DTC/Circuit Diagnosis >> DTC P0335: CKP Sensor >> Component Inspection (Crankshaft Position Sensor)

Component Inspection (Crankshaft Position Sensor)

WARNING: This page is about a different variant/trim than selected.
  1. CHECK CRANKSHAFT POSITION SENSOR-I 
    1. Turn ignition switch OFF.
    2. Loosen the fixing bolt of the sensor.
    3. Disconnect crankshaft position sensor harness connector.
    4. Remove the sensor.
    5. Visually check the sensor for chipping.
      GNSJMBIA0063Z-063Courtesy of NISSAN NORTH AMERICA, INC.

    Is the inspection result normal?

    YES

    GO TO 2.

    NO

    Replace crankshaft position sensor. Refer to Exploded View .

  2. CHECK CRANKSHAFT POSITION SENSOR-II 

    Check resistance between crankshaft position sensor terminals as per the following.

    Terminals (Polarity)

    Resistance

    1 (+) - 2 (-)

    Except 0 or INF.Ohm [at 25 deg.C (77 deg.F)]

    1 (+) - 3 (-)

    2 (+) - 3 (-)

    Is the inspection result normal?

    YES

    INSPECTION END

    NO

    Replace crankshaft position sensor. Refer to Exploded View .

scientia non olet · About LEMON Manuals