LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Control System (DTC/Circuit Diagnosis) (5.6L) (5 Of 6)) >> DTC/Circuit Diagnosis >> DTC P1451: Pressure Sensor >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different variant/trim than selected.
NOTE: Never refuel before and during the following procedure.
  1. CHECK DTC PRIORITY 

    If DTC P1451 is displayed with P0452 or P0453, first perform the trouble diagnosis for DTC P0452 or P0453.

    Is DTC P0452 or P0453 detected?

    YES

    Perform diagnosis of applicable.

    NO

    GO TO 2.

  2. PRECONDITIONING 

    If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.

    GO TO 3.

  3. PERFORM DTC CONFIRMATION PROCEDURE 
    1. Turn ignition switch ON.
    2. Check 1st trip DTC.

    Is 1st trip DTC detected?

    YES

    Proceed to DTC Diagnosis Procedure .

    NO

    To check malfunction symptom before repair: Refer to Intermittent Incident .

    NO

    Confirmation after repair: INSPECTION END