DTC Diagnosis Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK HOSE AND PIPING
- Turn ignition switch OFF.
- Check the following.
- Blockage, crush, or damage in the hose and piping of EVAP purge line between fuel tank and intake manifold.
- Blockage, crush, or damage in the hose and the piping of intake air passage between inlet air duct and intake manifold.
Is the inspection result normal?
YES
GO TO 2.
NO
Repair or replace error-detected parts
- CHECK EVAP CONTROL SYSTEM PRESSURE SENSOR
Check EVAP control system pressure sensor. Refer to Component Inspection (EVAP Control System Pressure Sensor) .
Is the inspection result normal?
YES
Check intermittent incident. Refer to Intermittent Incident .
NO
Replace EVAP control system pressure sensor.