LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 90 (Engine Cooling System) >> Removal And Installation >> Water Outlet And Water Piping >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Perform when the engine is cold.
  1. Remove the engine room cover. Refer to Removal and Installation .
  2. Partially drain coolant from radiator. Refer to Changing Engine Coolant .
  3. Remove front air duct. Refer to Removal and Installation .
  4. Remove the air duct and air cleaner assembly. Refer to Removal and Installation .
  5. Remove the front fender protector side cover (RH/LH). Refer to Exploded View .
  6. Disconnect the hoses from the electric throttle control actuator.
  7. Disconnect coolant hoses.
  8. Remove upper radiator hose and heater hoses.
  9. Remove connector(s) from heater pipe.
  10. Disconnect the harness connector from engine coolant temperature sensor.
  11. Remove water outlet, heater pipe, water connector, and water bypass pipe nuts and bolts.
  12. Remove the engine coolant temperature sensor if necessary.
scientia non olet · About LEMON Manuals