LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 90 (Engine Cooling System) >> Removal And Installation >> Radiator >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove radiator cap and drain engine coolant from radiator. Refer to Changing Engine Coolant .
    CAUTION:
    • Perform this step when the engine is cold.
    • Do not spill coolant on the drive belt.
  2. Remove fender protector side covers (LH/RH). Refer to Exploded View .
  3. Disconnect radiator hose (upper) and radiator hose (lower) from the radiator.
    CAUTION: Do not allow the coolant to contact the drive belt.
    NOTE: The radiator hose clamps on the radiator hose (upper) and on the radiator hose (lower) are not serviced separately. Radiator hose clamps are part of the radiator hose assembly and serviced as one unit with the radiator hose.
  4. Disconnect the CVT oil cooler hoses.
  5. Disconnect coolant reservoir hose from the radiator.
  6. Remove front air duct. Refer to Removal and Installation .
  7. Remove the front bumper fascia. Refer to Removal and Installation .
  8. Remove A/C condenser. Refer to Removal and Installation .
    CAUTION: Be careful not to damage condenser core.
  9. Remove the radiator mounts (upper).
  10. Remove radiator.
    CAUTION: Do not damage or scratch the radiator core when removing.
scientia non olet · About LEMON Manuals