Diagnosis Procedure
WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK BATTERY TEMPERATURE SENSOR INPUT SIGNAL
- Disconnect battery current sensor harness connector.
- Turn ignition switch ON.
- Check the voltage between battery current sensor harness connector and ground.
+
-
Voltage (V)
Battery current sensor
Connector
Terminal
F5
1
Ground
Approx. 5
Is the inspection result normal?
YES
GO TO 3.
NO
GO TO 2.
- CHECK BATTERY TEMPERATURE SENSOR INPUT SIGNAL CIRCUIT
- Turn ignition switch ON.
- Disconnect ECM harness connector.
- Check the continuity between battery current sensor harness connector and ECM harness connector.
+
-
Continuity
Battery current sensor
ECM
Connector
Terminal
Connector
Terminal
F5
2
F14
68
Existed
Is the inspection result normal?
YES
Perform the trouble diagnosis for power supply circuit.
NO
Repair or replace error-detected parts.
- CHECK BATTERY TEMPERATURE SENSOR GROUND CIRCUIT
- Turn ignition switch OFF.
- Disconnect ECM harness connector.
- Check the continuity between battery current sensor harness connector and ECM harness connector.
+
-
Continuity
Battery current sensor
ECM
Connector
Terminal
Connector
Terminal
F5
3
F14
64
Existed
- Also check harness for short to ground and short to power.
Is the inspection result normal?
YES
GO TO 4.
NO
Repair open circuit, short to ground or short to power in harness or connectors.
- CHECK BATTERY TEMPERATURE SENSOR
Check battery temperature sensor. Refer to Component Inspection (Battery Temperature Sensor) .
Is the inspection result normal?
YES
INSPECTION END
NO
Replace battery negative cable assembly.