Component Inspection
WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK CRANKSHAFT POSITION SENSOR (POS)-I
- Loosen the fixing bolt of the sensor.
- Disconnect crankshaft position sensor (POS) harness connector.
- Remove the sensor.
- Visually check the sensor for chipping.
Is the inspection result normal?
YES
GO TO 2.
NO
Replace crankshaft position sensor (POS). Refer to Exploded View .
- CHECK CRANKSHAFT POSITION SENSOR (POS)-II
Check the resistance between crankshaft position sensor (POS) terminals as per the following.
Crankshaft position sensor (POS)
Resistance [at 25°C (77°F)]
+
-
Terminal (Polarity)
1
2
Except 0 or ∞Ω
3
2
3
Is the inspection result normal?
YES
INSPECTION END
NO
Replace crankshaft position sensor (POS). Refer to Exploded View .