LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 86 (Engine Control System (DTC/Circuit Diagnosis) (2 Of 5)) >> DTC/Circuit Diagnosis >> DTC P0111: IAT Sensor >> Component Inspection

Component Inspection

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK INTAKE AIR TEMPERATURE SENSOR 
    1. Turn ignition switch OFF.
    2. Disconnect mass air flow sensor harness connector and reconnect it again.
    3. Turn ignition switch ON.
    4. Select "DATA MONITOR" mode with CONSULT.
    5. Check that the indicated value of "INT/A TEMP SEN" is almost the same as intake air temperature.

    Is the inspection result normal?

    YES

    INSPECTION END

    NO

    Replace mass air flow sensor (with intake air temperature sensor). Refer to Removal and Installation .

scientia non olet · About LEMON Manuals