DTC Confirmation Procedure
WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK DTC PRIORITY
If DTC "C1A13" is displayed with DTC "U1000", first diagnose the DTC "U1000".
Is applicable DTC detected?
YES
Perform diagnosis of applicable. Refer to DTC Logic .
NO
GO TO 2.
- PERFORM DTC CONFIRMATION PROCEDURE (1)
- Start the engine.
- Perform the active test item "STOP LAMP" with CONSULT.
- Perform "All DTC Reading".
- Check if the "C1A13" is detected as the current malfunction in the "Self Diagnostic Result" of "ICC/ADAS".
Is "C1A13" detected as the current malfunction?
YES
Refer to Diagnosis Procedure .
NO
GO TO 3.
- PERFORM DTC CONFIRMATION PROCEDURE (2)
- Drive at the vehicle speed of 40 km/h (25 MPH) or more for approximately 20 seconds or more without the brake pedal depressed.CAUTION: Always drive safely.NOTE: If it is outside the above condition, repeat step 1.
- Perform "All DTC Reading".
- Check if the "C1A13" is detected as the current malfunction in the "Self Diagnostic Result" of "ICC/ADAS".
Is "C1A13" detected as the current malfunction?
YES
Refer to Diagnosis Procedure .
NO
To check malfunction symptom before repair: Refer to Intermittent Incident .
NO
Confirmation after repair: INSPECTION END
- Drive at the vehicle speed of 40 km/h (25 MPH) or more for approximately 20 seconds or more without the brake pedal depressed.