Component Inspection
WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK CRANKSHAFT POSITION (CKP) SENSOR-I
- Turn ignition switch OFF.
- Loosen the fixing bolt of the sensor.
- Disconnect CKP sensor harness connector.
- Remove the sensor.
- Visually check the sensor for chipping.
Is the inspection result normal?
YES
GO TO 2.
NO
Replace CKP sensor. Refer to Exploded View .
- CHECK CKP SENSOR-II
Check the resistance between CKP sensor terminals as per the following.
CKP sensor
Condition
Resistance
Terminal (Polarity)
1
2
Temperature [ deg.C (deg.F)]
25 (77)
Except 0 or INF.Ohm
3
2
3
Is the inspection result normal?
YES
INSPECTION END
NO
Replace CKP sensor. Refer to Exploded View .