Diagnosis Procedure
WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK MODE DOOR MOTOR (REAR) COMMUNICATION SIGNAL
- Turn ignition switch ON.
- Check output waveform between mode door motor (rear) harness connector and ground with the oscilloscope.
+
-
Output waveform
Mode door motor (rear)
Connector
Terminal
M13
2
Ground
Is the inspection result normal?
YES
GO TO 2.
NO
GO TO 3.
- CHECK INSTALLATION OF MODE DOOR MOTOR (REAR)
Check mode door motor (rear) is properly installed. Refer to Exploded View .
Is the inspection result normal?
YES
Replace mode door motor (rear). Refer to Removal and Installation - Mode Door Motor (Rear) .
NO
Repair or replace malfunctioning part.
- CHECK MODE DOOR MOTOR (REAR) COMMUNICATION SIGNAL CIRCUIT
- Turn ignition switch OFF.
- Disconnect mode door motor (rear) and A/C auto amp. connector.
- Check continuity between mode door motor (rear) harness connector and A/C auto amp. harness connector.
Mode door motor (rear)
A/C auto amp.
Continuity
Connector
Terminal
Connector
Terminal
M13
2
M50
16
Yes
Is the inspection result normal?
YES
Replace A/C auto amp. Refer to Removal and Installation .
NO
Repair harness or connector.