Removal and Installation: Removal
WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect negative and positive battery terminals, then wait at least three minutes. Refer to Removal and Installation .
- Remove the front air duct. Refer to EXPLODED VIEW .
- Disconnect the harness connector from the crash zone sensor.
- Remove the crash zone sensor bolt.CAUTION: Do not reuse the crash zone sensor bolt.
- Remove the crash zone sensor.CAUTION:
- Replace the crash zone sensor if it has been dropped or sustained an impact.
- Do not strike the crash zone sensor.
- Replace the crash zone sensor if either the driver air bag or the front passenger air bag has been deployed.