Removal and Installation: Removal

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Do not spill or splash brake fluid on painted areas; it may cause paint damage. If brake fluid is splashed on painted areas, wash it away with water immediately.
Do not reuse master cylinder O-rings.
Do not reuse drained brake fluid.

NOTE: When removing components such as hoses, tubes/lines, etc., cap or plug openings to prevent fluid from spilling.

Disconnect the harness connector from the brake fluid level sensor.
Remove air duct assembly and air cleaner case. Refer to EXPLODED VIEW .
Disconnect the hose from the reservoir tank.
Disconnect the brake pipes from the master cylinder assembly with a flare nut wrench.
CAUTION: Do not scratch the flare nut or the brake pipe.
Remove the master cylinder assembly.
CAUTION: Do not depress the brake pedal after the master cylinder assembly is removed.