Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect CVT unit connector.
3. Check resistance between CVT unit connector terminals.

   CVT unit		Condition	Resistance (Approx.)
   Connector	Terminal
   F209	12 - 18	CVT fluid temperature: 20 deg.C (68 deg.F)	6.5 kOhm
   		CVT fluid temperature: 50 deg.C (122 deg.F)	2.2 kOhm
   		CVT fluid temperature: 80 deg.C (176 deg.F)	0.87 kOhm

Is the inspection result normal?

YES

GO TO 2.

NO

GO TO 4.

1. Disconnect the TCM connector.
2. Check continuity between TCM harness connector terminals and CVT unit harness connector terminals.

   TCM		CVT unit		Continuity
   Connector	Terminal	Connector	Terminal
   F25	11	F43	18	Existed
   	12		12

Is the inspection result normal?

YES

GO TO 3.

NO

Repair or replace damaged parts.

Check continuity between TCM harness connector terminals and ground.

Is the inspection result normal?

YES

Check intermittent incident. Refer to Intermittent Incident .

NO

Repair or replace damaged parts.

1. Remove terminal cord assembly. Refer to Exploded View .
2. Check continuity between CVT unit harness connector terminals and control valve harness connector terminals.

   CVT unit		Control valve		Continuity
   Connector	Terminal	Connector	Terminal
   F209	18	F207	13	Existed
   	12		5

Is the inspection result normal?

YES

GO TO 5.

NO

Repair or replace damaged parts.

Check terminal cord assembly harness cladding for damage.

Is the inspection result normal?

YES

GO TO 6.

NO

Repair or replace damaged parts.

With CONSULT

1. Perform "DTC CONFIRMATION PROCEDURE". Refer to DTC Confirmation Procedure .
2. Select "Self Diagnostic Results" in "TRANSMISSION".

Is "P0711" detected?

YES

There is a malfunction of the CVT fluid temperature sensor. Replace the terminal code assembly. Refer to Removal and Installation .

NO

Check intermittent incident. Refer to Intermittent Incident .