Symptom Table

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD, 2019 Nissan NV2500 HD, and 2019 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Perform the self-diagnosis with CONSULT before the symptom diagnosis. Perform the trouble diagnosis if any DTC is detected.

Symptom		Possible cause	Inspection item
Headlamp does not switch to the high beam.	One side	Fuse Harness between IPDM E/R and the front combination lamp Front combination lamp (High beam relay) IPDM E/R	Headlamp (HI) circuit Refer to Diagnosis Procedure - For USA (for USA). Refer to Diagnosis Procedure - For Canada (for Canada).
Headlamp does not switch to the high beam.	Both sides	Symptom diagnosis "BOTH SIDE HEADLAMPS DO NOT SWITCH TO HIGH BEAM" Refer to Diagnosis Procedure .
High beam indicator lamp is not turned ON. (Headlamp switches to the high beam.)		Combination meter BCM	Combination meter. Data monitor "HI-BEAM IND" BCM (HEAD LAMP) Active test "HEADLAMP"
Headlamp does not switch to the low beam.	One side	Front combination lamp (low beam relay)	--
	Both sides	Combination switch (high beam and turn signal switch) Harness between the combination switch (high beam and turn signal switch) and BCM BCM	Combination switch (high beam and turn signal switch) Refer to Symptom Table .
		High beam request signal BCM IPDM E/R	IPDM E/R Data monitor "HL HI REQ"
		IPDM E/R	--
Headlamp does not turn ON.	One side	Fuse Bulb Harness between IPDM E/R and the front combination lamp Front combination lamp IPDM E/R	Headlamp (LO) circuit Refer to Diagnosis Procedure - For USA (for USA). Refer to Diagnosis Procedure - For Canada (for Canada).
Headlamp does not turn ON.	Both sides	Symptom diagnosis "BOTH SIDE HEADLAMPS (LO) ARE NOT TURNED ON" Refer to Diagnosis Procedure .
Headlamp does not turn OFF.	When the ignition switch is turned ON	BCM Lighting switch	Lighting switch Refer to Symptom Table .
Daytime running light system does not activate.		Either high beam bulb (Canada) Either low beam bulb (USA) Parking brake switch Lighting switch BCM IPDM E/R Daytime running light relays Harness between IPDM E/R and daytime running light relays.	Daytime running light system description. Refer to System Description - For USA (for USA). Refer to System Description - For Canada (for Canada).
Front fog lamp is not turned ON.	One side	Front fog lamp bulb Harness between IPDM E/R and the front fog lamp IPDM E/R	Front fog lamp circuit Refer to Diagnosis Procedure .
Front fog lamp is not turned ON.	Both sides	Symptom diagnosis "BOTH SIDE FRONT FOG LAMPS ARE NOT TURNED ON" Refer to Diagnosis Procedure .
Parking lamp is not turned ON.	One side	Fuse Parking lamp bulb Harness between IPDM E/R and the front/rear combination lamp Front/rear combination lamp IPDM E/R	Parking lamp circuit Refer to Diagnosis Procedure .
Parking lamp is not turned ON.	Both sides	Symptom diagnosis "PARKING, LICENSE PLATE AND TAIL LAMPS ARE NOT TURNED ON" Refer to Diagnosis Procedure .
Turn signal lamp does not blink.	Indicator lamp is normal. (The applicable side performs the high flasher activation).	Harness between BCM and each turn signal lamp Turn signal lamp bulb	Turn signal lamp circuit Refer to Diagnosis Procedure .
Turn signal indicator lamp does not blink.	One side	Combination meter	--
	Both sides (Always)	Turn signal indicator lamp signal Combination meter BCM	Combination meter. Data monitor "TURN IND" BCM (FLASHER) Active test "FLASHER"
	Both sides (Does blink when activating the hazard warning lamp with the ignition switch OFF)	The combination meter power supply and the ground circuit Combination meter	Combination meter Power supply and the ground circuit Refer to Diagnosis Procedure .