DTC Diagnosis Procedure

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD, 2019 Nissan NV2500 HD, and 2019 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.

CHECK STARTING SYSTEM
Turn ignition switch to START position.

Does the engine turn over? Does the starter motor operate?

YES

GO TO 2.

NO

Check starting system. (Refer to Work Flow .)

CHECK CAMSHAFT POSITION (CMP) SENSOR (PHASE) POWER SUPPLY

Disconnect camshaft position (CMP) sensor (PHASE) harness connector.
Turn ignition switch ON.

Check the voltage between CMP sensor (PHASE) harness connector and ground.

+			-	Voltage (Approx.)
CMP sensor (PHASE)
Bank	Connector	Terminal
2	F76	3	Ground	Battery voltage

Is the inspection result normal?

YES

GO TO 4.

GO TO 3.

CHECK CMP SENSOR (PHASE) POWER SUPPLY CIRCUIT

Turn ignition switch OFF.
Disconnect IPDM E/R harness connector.

Check the continuity between CMP sensor (PHASE) harness connector and IPDM E/R harness connector.

+			-		Continuity
CMP sensor (PHASE)			IPDM E/R
Bank	Connector	Terminal	Connector	Terminal
2	F76	3	E119	4	Existed

Is the inspection result normal?

YES

Perform the trouble diagnosis for power supply circuit.

Repair or replace error-detected parts.

CHECK CMP SENSOR (PHASE) GROUND CIRCUIT

Turn ignition switch OFF.

Check the continuity between CMP sensor (PHASE) harness connector and ground.

+			-	Continuity
CMP sensor (PHASE)
Bank	Connector	Terminal
2	F76	1	Ground	Existed

Also check harness for short to power.

Is the inspection result normal?

YES

GO TO 5.

Repair or replace error-detected parts.

CHECK CMP SENSOR (PHASE) INPUT SIGNAL CIRCUIT

Disconnect ECM harness connector.

Check the continuity between CMP sensor (PHASE) harness connector and ECM harness connector.

+			-		Continuity
CMP sensor (PHASE)			ECM
Bank	Connector	Terminal	Connector	Terminal
2	F76	2	F77	89	Existed

Also check harness for short to ground and short to power.

Is the inspection result normal?

YES

GO TO 6.

Repair or replace error-detected parts.

CHECK CAMSHAFT POSITION SENSOR (PHASE)
Refer to Component Inspection .

Is the inspection result normal?

YES

GO TO 7.

NO

Replace malfunctioning camshaft position sensor (PHASE).

CHECK CAMSHAFT (INTAKE)

Check the following.

Accumulation of debris to the signal plate of camshaft front end

Courtesy of NISSAN NORTH AMERICA, INC.

Chipping signal plate of camshaft front end

Is the inspection result normal?

YES

Check intermittent incident. Refer to Intermittent Incident .

Remove debris and clean the signal plate of camshaft front end or replace camshaft.