LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 476 (Engine Control System (DTC/Circuit Diagnosis) (3 Of 3)) >> DTC/Circuit Diagnosis >> Variable Induction Air Control System (VIAS) >> Component Inspection (VIAS Control Solenoid Valve)

Component Inspection (VIAS Control Solenoid Valve)

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD, 2019 Nissan NV2500 HD, and 2019 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK VIAS CONTROL SOLENOID VALVE 

    SYMBOL With CONSULT

    1. Reconnect harness connectors disconnected.
    2. Turn ignition switch ON.
    3. Perform "VIAS SOL VALVE" in "ACTIVE TEST" mode of "ENGINE".
    4. Check air passage continuity and operation delay time as per the following conditions.
      GNSJMBIA0180Z-180Courtesy of NISSAN NORTH AMERICA, INC.

      VIAS SOL VALVE

      Air passage continuity

      between (A) and (B)

      Air passage continuity

      between (A) and (C)

      ON

      Yes

      No

      OFF

      No

      Yes

      Operation takes less than 1 second.

    SYMBOL Without CONSULT

    Check air passage continuity and operation delay time as per the following conditions.

    G04148505Courtesy of NISSAN NORTH AMERICA, INC.

    Condition

    Air passage continuity

    between (A) and (B)

    Air passage continuity

    between (A) and (C)

    12V direct current supply between terminals 1 and 2

    Yes

    No

    No supply

    No

    Yes

    Operation takes less than 1 second.

    Is the inspection result normal?

    YES

    INSPECTION END

    NO

    Replace VIAS control solenoid valve. Refer to Exploded View .