LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 476 (Engine Control System (DTC/Circuit Diagnosis) (3 Of 3)) >> DTC/Circuit Diagnosis >> DTC P1564: ASCD Steering Switch >> DTC Diagnosis Procedure

DTC Diagnosis Procedure

WARNING: This page is about a different car, the 2019 Nissan NV3500 HD, 2019 Nissan NV2500 HD, and 2019 Nissan NV1500. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK ASCD STEERING SWITCH CIRCUIT 

    SYMBOL With CONSULT

    1. Turn ignition switch ON.
    2. Select "CANCEL SW", "RESUME/ACC SW" and "SET SW" in "DATA MONITOR" mode of "ENGINE" using CONSULT.
    3. Check each item indication as per the following conditions.

      Monitor item

      Condition

      Indication

      MAIN SW

      MAIN switch

      Pressed

      ON

      Released

      OFF

      CANCEL SW

      CANCEL switch

      Pressed

      ON

      Released

      OFF

      RESUME/ACC SW

      ACCEL/RES switch

      Pressed

      ON

      Released

      OFF

      SET SW

      COAST/SET switch

      Pressed

      ON

      Released

      OFF

    SYMBOL Without CONSULT

    1. Turn ignition switch ON.
    2. Check the voltage between ECM harness connector terminals.

      ECM

      Condition

      Voltage

      (Approx.)

      +

      -

      Connector

      Terminal

      Connector

      Terminal

      E16

      134

      E16

      135

      MAIN switch: Pressed

      0 V

      CANCEL switch: Pressed

      1 V

      COAST/SET switch: Pressed

      2 V

      ACCEL/RES switch: Pressed

      3 V

      All ASCD steering switches: Released

      4 V

    Is the inspection result normal?

    YES

    Check intermittent incident. Refer to Intermittent Incident .

    NO

    GO TO 2.

  2. CHECK ASCD STEERING SWITCH GROUND CIRCUIT 
    1. Turn ignition switch OFF.
    2. Disconnect ECM harness connector.
    3. Disconnect spiral cable harness connector.
    4. Check the continuity between spiral cable harness connector and ECM harness connector.

      +

      -

      Continuity

      Spiral cable

      ECM

      Connector

      Terminal

      Connector

      Terminal

      M30

      32

      E16

      135

      Existed

    5. Also check harness for short to ground and to power.

    Is the inspection result normal?

    YES

    GO TO 3.

    NO

    Repair or replace error-detected parts.

  3. CHECK ASCD STEERING SWITCH INPUT SIGNAL CIRCUIT 
    1. Check the continuity between ECM harness connector and spiral cable harness connector.

      +

      -

      Continuity

      Spiral cable

      ECM

      Connector

      Terminal

      Connector

      Terminal

      M30

      25

      E16

      134

      Existed

    2. Also check harness for short to ground and to power.

    Is the inspection result normal?

    YES

    GO TO 4.

    NO

    Repair or replace error-detected parts.

  4. CHECK ASCD STEERING SWITCH 

    Refer to Component Inspection .

    Is the inspection result normal?

    YES

    Check intermittent incident. Refer to Intermittent Incident .

    NO

    Replace ASCD steering switch. Refer to Exploded View .