DTC Confirmation Procedure
WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Be careful of the driving speed.
- PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.
GO TO STEP 2 .
- PREPARATION BEFORE OPERATION
With CONSULT
- Start the engine.
- Select "Data Monitor" in "TRANSMISSION".
- Select "FLUID TEMP".
- Confirm that the CVT fluid temperature is in the following range.
FLUID TEMP
: 20°C (68°F) or more
With GST
- Start the engine.
- Set the CVT fluid to 20°C (68°F) or more.NOTE: When the ambient temperature is 20°C (68°F), the CVT fluid usually increases to 50 to 80°C (122 to 176°F) with driving in an urban area for approximately 10 minutes.
Is the CVT fluid 20°C (68°F) or more?
YES
GO TO STEP 3 .
NO
- Warm the transaxle.
- GO TO STEP 3 .
- CHECK DTC DETECTION
- Drive the vehicle.
- Maintain the following conditions for 10 seconds or more.
Selector lever
: "D" position
Vehicle speed
: 40 km/h (25 MPH) or more
- Stop the vehicle.
- Check the first trip DTC.
Is "P0743" detected?
YES
Go to Diagnosis Procedure .
NO
To check malfunction symptom before repair: Refer to Intermittent Incident .
NO
Confirmation after repair: INSPECTION END