LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Cruise Control System (DTC/Circuit Diagnosis)) >> DTC / Circuit Diagnosis >> DTC C1A06: Operation SW >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK DTC PRIORITY 

    If DTC "C1A06" is displayed with DTC "U1000", first diagnose the DTC "U1000".

    Is applicable DTC detected?

    YES

    Perform diagnosis of applicable DTC. Refer to DTC Logic .

    NO

    GO TO 2.

  2. PERFORM DTC CONFIRMATION PROCEDURE 

    SYMBOL CONSULT

    1. Start the engine.
    2. Wait for approximately 5 minutes after turning the MAIN switch of ICC system ON.
    3. Select "Self Diagnostic Result" mode of "LASER/RADAR".
    4. Check if the "C1A06" is detected as the current malfunction in "Self Diagnostic Result" mode of "LASER/RADAR".

    Is "C1A06" detected as the current malfunction?

    YES

    Refer to Diagnosis Procedure .

    NO

    To check malfunction symptom before repair: Refer to Intermittent Incident .

    NO

    Confirmation after repair: Inspection End.

scientia non olet · About LEMON Manuals