LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 339 (Engine Control System (6 Of 6)) >> Removal And Installation >> Fuel Pump Control Module (FPCM) >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2019 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery negative terminal. Refer to Removal and Installation .
  2. Remove storage box side finisher (LH). Refer to Removal and Installation .
  3. Pull back second row seat lower seat belt anchor cover (LH) and remove lower anchor bolt (LH). Refer to Second Row Seat Belt .
  4. Disconnect Intelligent Key antenna harness connector from storage box front brackets.
  5. Remove storage box side finisher brackets. Refer to Exploded View .
  6. Remove third row seats. Refer to Removal and Installation .
  7. Remove third row seat lower seat belt anchor cover (LH) and remove lower anchor bolt (LH). Refer to Third Row Seat Belt .
  8. Remove luggage side lower finisher (LH). Refer to Removal and Installation .
  9. Disconnect the harness connector from fuel pump control module.
  10. Remove nut and bolt from bracket and remove fuel pump control module.
  11. Remove bolts and fuel pump control module bracket (if necessary).
scientia non olet · About LEMON Manuals