Removal and Installation: Installation
WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Do not allow foreign matter (e.g. dust) and oils other than brake fluid to enter the reservoir tank.
- Assemble union bolt (A) and the copper sealing washers (1) to brake hose and install it as an assembly to brake caliper. Align brake hose L-pin by aligning it with brake caliper hole, and tighten union bolt (A) to specified torque.CAUTION: Do not reuse copper sealing washers.
- Install brake hose to brake tube. Temporarily tighten flare nut by hand until it does not rotate further. Secure brake hose to bracket with lock plate.CAUTION: Check that brake hoses and pipes are not bent or twisted.
- Tighten flare nut to the specified torque using a flare nut crowfoot and torque wrench. Refer to Exploded View .CAUTION: Do not scratch flare nut or brake tube.
- Refill brake fluid and perform the air bleeding procedure. Refer to Bleeding Brake System .CAUTION: Do not reuse drained brake fluid.
- Install wheels and tires using a power tool. Refer to Removal and Installation .
- Perform inspection after installation. Refer to Inspection .