LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Brake System) >> Removal And Installation >> Brake Piping >> Front >> Removal and Installation >> Installation

Removal and Installation: Installation

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Do not allow foreign matter (e.g. dust) and oils other than brake fluid to enter the reservoir tank.
  1. Assemble union bolt and new copper sealing washers on brake hose.
    CAUTION: Do not reuse the copper sealing washers.
  2. Install brake hose to brake tube. Temporarily tighten flare nut by hand until it does not rotate further. Secure brake hose to bracket with lock plate.
    CAUTION: Check that the brake hoses and pipes are not bent or twisted.
  3. Tighten flare nut to specified torque using a flare nut crowfoot and torque wrench. Refer to Exploded View .
    CAUTION: Do not scratch flare nut or brake tube.
  4. Refill brake fluid and perform air bleeding procedure. Refer to Bleeding Brake System .
  5. Install wheels and tires using a power tool. Refer to Removal and Installation .
  6. Perform inspection after installation. Refer to Inspection .
scientia non olet · About LEMON Manuals