LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Front Axle) >> Removal And Installation >> Front Wheel Hub And Bearing >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove disc brake rotor. Refer to Removal and Installation .
  2. Remove front wheel sensor bolt (A) and front wheel sensor from steering knuckle. Refer to Exploded View .
    GNSALDIA0287Z-287Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION:
    • Failure to separate front wheel sensor from steering knuckle may result in damage to front wheel sensor.
    • Pull out front wheel sensor being careful to turn it as little as possible. Do not pull on wheel sensor harness.
  3. Remove cotter pin.
  4. Remove nut retainer.
  5. Loosen wheel hub lock nut from drive shaft using a power tool.
  6. Using a piece of wood and a suitable tool, tap on the wheel hub lock nut to disengage drive shaft from wheel hub and bearing.
    GNSJPDIG0070Z-070Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION:
    • Do not place drive shaft joint to an extreme angle. Also be careful not to overextend slide joint.
    • Do not allow drive shaft to hang down without support.
    NOTE: Use a suitable puller if drive shaft cannot be separated from wheel hub and bearing.
  7. Remove wheel hub lock nut.
  8. Remove wheel hub and bearing bolts using a power tool.
  9. Remove splash guard and wheel hub and bearing from steering knuckle.
  10. If necessary, remove wheel studs (1) using a suitable tool (A).
    GNSJPDIF0299Z-299Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals