Removal and Installation: Removal

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

To remove brake tube, use a flare nut wrench to prevent flare nuts and brake tube from being damaged.
Do not remove actuator by holding harness.

NOTE: When removing components such as hoses, tubes/lines, etc., cap or plug openings to prevent fluid from spilling.

Disconnect battery negative terminal. Refer to Battery Disconnect .
Remove cowl top and cowl top extension. Refer to Removal and Installation .
Remove nuts (A) and power steering line hold down bracket (1).

Courtesy of NISSAN NORTH AMERICA, INC.
Disconnect harness connector from ABS actuator and electric unit (control unit) and position aside.
Loosen brake tube flare nuts using a suitable tool, then remove brake tubes from ABS actuator and electric unit (control unit) and position aside. Refer to Exploded View .
Remove harness bracket bolt.

Courtesy of NISSAN NORTH AMERICA, INC.
Remove ABS actuator and electric unit (control unit) and bracket as an assembly.
If necessary, remove bracket from ABS actuator and electric unit (control unit).