LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 213 (Engine Lubrication System (CUMMINS 5.0L)) >> Symptom Diagnosis >> Engine Lubrication System Symptoms >> Lubricating Oil Consumption Excessive

Lubricating Oil Consumption Excessive

WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.

Symptom

Possible Cause

Action

Reference

Lubricating Oil Consumption Excessive

Verify the oil consumption rate

Check the amount of oil added versus the mileage.

-

Lubricating oil leak (external)

Inspect the engine for external oil leaks. Tighten bolts and fittings. Replace gaskets, if necessary.

Inspection 

Crankcase ventilation system is plugged

Check and clean the crankcase breather and vent tube.

Removal and Installation

Lubricating oil does not meet specifications for operating conditions.

Change the oil and oil filter. Also see lubricating oil recommendations and specifications.

Changing Engine Oil 

Removal and Installation 

Cummins 5.0L Engine : Fluids and Lubricants

Lubricating oil drain interval is excessive

Verify the correct lubricating oil drain interval. Refer to the maintenance schedule.

Introduction of Periodic Maintenance

Oil cooler is leaking

Check the oil cooler for coolant leaks. Refer to Coolant Loss - Internal symptom diagnosis.

Coolant Loss - Internal

Lubricating oil level is above specification

Check the oil level. Fill the system to the specified level.

Inspection 

Engine angularity during operation excessive

Operate the vehicle on a level surface and re-check.

-

Turbocharger oil seal is leaking

Check the turbocharger compressor and turbine seals for signs of an oil leak.

Inspection

Lubricating oil is contaminated with coolant or fuel

Refer to the Lubricating Oil Contaminated symptom diagnosis.

Lubricating Oil Contaminated 

Valve stem clearance is excessive or the valve stem seals are damaged

Check the valve stems and seals.

Disassembly and Assembly

Piston rings are not seated correctly (after an engine rebuild or piston installation, or new engine installation)

Check for excessive blowby. Refer to Crankcase Gases (Blowby) Excessive symptom diagnosis.

Crankcase Gases (Blowby) Excessive

Piston rings are worn or damaged

Check for air intake system leaks. Check the pistons and piston rings for wear or damage. Analyze the oil and inspect the oil filter to locate an area of probable damage.

Inspection

Internal engine damage

Analyze the oil and inspect the oil filter to locate an area of probable damage.

Inspection 

Removal and Installation