LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 211 (Engine Control System (DTC/Circuit Diagnosis) (CUMMINS 5.0L) (1 Of 6)) >> DTC/Circuit Diagnosis >> DTC P0116-00: ECT Sensor >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.
  1. PRECONDITIONING 

    If DTC CONFIRMATION PROCEDURE has been previously conducted, always perform the following procedure before conducting the next test.

    1. Turn ignition switch OFF.
    2. Allow the engine to stay OFF for 8 hours.
    3. Start vehicle and accelerate to 88 km/h (55 MPH) for 2 minutes.
      CAUTION: Always drive vehicle at safe speed.
    4. Perform coast down event from 88 km/h (55 MPH) to 72 km/h (45 MPH) for 2 minutes.
    5. Accelerate to 88 km/h (55 MPH) for 20 seconds.
    6. Repeat steps 4 and 5 for 21 times.
    7. Turn ignition switch OFF.

    GO TO 2 .

  2. PERFORM DTC CONFIRMATION PROCEDURE 
    1. Turn ignition switch ON.
    2. Check 1st trip DTC.
    3. Connect CONSULT and check for current ENGINE diagnostic trouble codes.
    4. Check for DTC P0116-00 being current on the CONSULT screen.

    Is P0116-00 DTC current?

    YES

    Go to Diagnosis Procedure .

    NO

    Inspection End.

scientia non olet · About LEMON Manuals