LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 208 (Engine Control System (DTC/Circuit Diagnosis) (CUMMINS 5.0L) (5 Of 6)) >> DTC/Circuit Diagnosis >> DTC P2299-00: Accelerator/Brake Pedal Position Inconsistency >> Diagnosis Procedure

Diagnosis Procedure

WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK DTC PRIORITY 
    1. Turn ignition switch ON.
    2. Connect CONSULT and check for other existing ENGINE diagnostic trouble codes.
    3. If there are any ABS related DTCs, perform the confirmation procedure (trouble diagnosis) for these other DTCs first.

    Is any applicable ABS related DTC detected?

    YES

    Refer to DTC Index .

    NO

    GO TO 2 .

  2. VERIFY DTC CAUSE 
    NOTE: This DTC can trip if the customer is a two-footed driver (customer rests a foot on the brake pedal while using the accelerator pedal).

    Determine whether the brake pedal has been depressed while the vehicle is moving and the throttle position is greater than 8% for 2 seconds.

    Is the driver a two-footed driver?

    YES

    Explain the diagnostic operation to the customer. Repair complete.

    NO

    GO TO 3.

  3. CHECK BRAKE PEDAL POSITION SWITCH 
    1. Turn ignition switch OFF.
    2. Verify brake pedal switch adjustment. Refer to Inspection

    Is the inspection normal?

    YES

    Replace the ECM. Refer to Removal and Installation .

    NO

    Adjust brake pedal switch. Refer to Adjustment

scientia non olet · About LEMON Manuals