LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 208 (Engine Control System (DTC/Circuit Diagnosis) (CUMMINS 5.0L) (5 Of 6)) >> DTC/Circuit Diagnosis >> DTC P2267-00: Water In Fuel Sensor Circuit High >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.
  1. PRECONDITIONING 

    If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test:

    1. Turn ignition switch OFF.
    2. Start the engine and let it idle for 1 minute.
    3. Turn ignition switch OFF.

    GO TO 2 .

  2. PERFORM DTC CONFIRMATION PROCEDURE 
    1. Turn ignition switch ON.
    2. Check 1st trip DTC.
    3. Connect CONSULT and check for current "ENGINE" diagnostic trouble codes.
    4. Check for DTC P2267-00 being current on the CONSULT screen.

    Is P2267-00 DTC current?

    YES

    Go to Diagnosis Procedure .

    NO

    Inspection End.

scientia non olet · About LEMON Manuals