LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 208 (Engine Control System (DTC/Circuit Diagnosis) (CUMMINS 5.0L) (5 Of 6)) >> DTC/Circuit Diagnosis >> DTC P2080-00: Exhaust Gas Temperature Sensor 1 >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.
  1. PERFORM DTC CONFIRMATION PROCEDURE 

    If DTC CONFIRMATION PROCEDURE has been previously conducted, always perform the following procedure before conducting the next test.

    1. Start the vehicle and accelerate to 88 km/h (55 MPH) for 2 minutes.
      CAUTION: Always drive vehicle at safe speed.
    2. Decelerate to 73 km/h (45 MPH) by releasing the accelerator pedal completely.
    3. Accelerate to 88 km/h (55 MPH) for 20 seconds.
    4. Repeat steps 2 and 3 for 21 times.
    5. Bring the vehicle to a complete stop.
    6. Repeat all of the above steps one more time.
    7. Connect CONSULT and check for current ENGINE diagnostic trouble codes.
    8. Check for DTC P2080-00 being current on the CONSULT screen.

    Is 1st trip DTC detected?

    YES

    Proceed to Diagnosis Procedure .

    NO

    Inspection End.

scientia non olet · About LEMON Manuals