DTC Confirmation Procedure
WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.
- PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" is previously conducted, always turn ignition switch OFF and wait at least 25 seconds before performing the next test.
GO TO 2 .
- CHECK DTC DETECTION
- Clear the DTC.
- Start the engine.
- Repeat the following steps 3 to 4 for two times.
- Sift the selector lever to "R" position for at least 10 seconds.
- Sift the selector lever to "P" position.
- Check the DTC.
Is "P2803" detected?
YES
Refer to Diagnosis Procedure .
NO
To check malfunction symptom before repair: Refer to Intermittent Incident .
NO
Confirmation after repair: INSPECTION END