Diagnosis Procedure

Check the metal deposition, damage, and corrosion of connectors (F212 and E73 and E74).

Is the inspection result normal ?

YES

GO TO 2 .

NO

Repair or replace malfunctioning parts.

Is the transmission range switch installed correctly?

YES

GO TO 3 .

NO

Repair or replace malfunctioning parts.

Is the control cable installed correctly?

YES

GO TO 4 .

NO

Repair or replace malfunctioning parts.

Check following items:

• Harness open circuit or short circuit between transmission range switch harness connector and accessory relay-2.
• Harness open circuit or short circuit between accessory relay-2 and fuse block (J/B).
• 5A fuse (No. 25)
• Accessory relay
• Battery

Is the check result normal?

YES

GO TO 5 .

NO

Repair or replace malfunctioning parts.

1. Turn ignition switch OFF.
2. Disconnect transmission range switch connector.
3. Turn ignition switch ON.
4. Check voltage between transmission range switch harness connector terminal and ground.

   Transmission range switch		-	Voltage
   Connector	Terminal
   F212	3	Ground	Battery voltage

Is the check result normal?

YES

GO TO 6 .

NO

GO TO 4 .

1. Turn ignition switch OFF.
2. Connect transmission range switch connector.
3. Disconnect TCM connector.
4. Turn ignition switch ON.
5. Shift the selector lever from P to D and check voltage between TCM harness connector terminal and ground.

   TCM		-	Condition	Voltage
   Connector	Terminal
   E74	21	Ground	Selector lever: P	Battery voltage
   			Selector lever: Between P and R	Battery voltage
   			Selector lever: R	0 V
   			Selector lever: Between R and N	Battery voltage
   			Selector lever: N	Battery voltage
   			Selector lever: Between N and D	Battery voltage
   			Selector lever: D	0 V

Is the check result normal?

YES

INSPECTION END

NO

GO TO 7 .

Check continuity between TCM harness connector terminals.

Continuity should not be existed.

Is the check result normal?

YES

GO TO 5 .

NO

Repair or replace malfunctioning parts.