Low Tire Pressure Warning Lamp Symptom Chart

WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.

Diagnosis items	Symptom (Ignition switch ON)	Low tire pressure warning lamp	Cause	Action
Low tire pressure warning lamp	The low tire pressure warning lamp illuminates for 1 second, then turns OFF.	Courtesy of NISSAN NORTH AMERICA, INC.	Wake-up operation for all tire pressure sensors at wheels is completed.	No system malfunctions
	The low tire pressure warning lamp turns ON and stays illuminated.	Courtesy of NISSAN NORTH AMERICA, INC.	Low tire pressure	Check the tire pressure for all wheels and adjust to the specified value. Refer to Tire .
			Tire pressure monitoring system configuration not performed.	Perform configuration. Refer to Work Procedure .
			Tire pressure sensor ID registration not performed.	Perform ID registration. Refer to Work Procedure .
Low tire pressure warning lamp	The low tire pressure warning lamp repeats blinking at 0.5-second intervals for 1 minute, and then stays illuminated.	Courtesy of NISSAN NORTH AMERICA, INC.	The low tire pressure warning control unit cannot detect tire pressure data signal.	Check visually that the tire pressure sensors are installed. If necessary, replace/install the tire pressure sensor(s) and perform tire pressure sensor ID registration. Refer to Work Procedure . Remove the interference radio wave (e.g. battery charger of smart phone).
			The combination meter fuse is open or removed (or pulled out).	Check and install the combination meter fuse. If necessary, replace the fuse.
			The low tire pressure warning control unit harness connector is removed.	Check the connection conditions of the low tire pressure warning control unit harness connector, and repair if necessary.
			Tire Pressure Monitoring System (TPMS) malfunction. (except tire pressure monitoring system configuration and/or tire pressure sensor ID registration non-performed)	Perform CONSULT self-diagnosis. Refer to CONSULT Function .
Hazard warning lamp	The hazard warning lamp does not blink twice when performing ID registration operation.	-	ID registration is not completed.	Perform "ID REGISTRATION CANNOT BE COMPLETED" diagnosis procedure. Refer to Diagnosis Procedure .