Work Procedure

WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

After configuration, perform the following:
- Turn the ignition switch from OFF to ON and check that the low tire pressure warning lamp turns OFF after staying illuminated for approximately two seconds.
- Perform tire pressure sensor ID registration. Refer to Work Procedure .
If TPMS configuration is not completed, TPMS transmitter ID registration will not complete.

CHECKING ECU IDENTIFICATION NUMBER
CONSULT
1. Select "ECU Identification" of "AIR PRESSURE MONITOR".
2. Write down ECU part number.
GO TO 2 .
RE/PROGRAMMING, CONFIGURATION
CONSULT
1. Select "Re/programming, Configuration" from home screen.
2. Check box confirming the precautions have been read.
3. Select "Next".
Is "Manual Selection (Vehicle Name)" displayed?

YES

GO TO 3 .

NO

GO TO 4 .
VEHICLE SELECTION
CONSULT
1. Select Vehicle Make, Vehicle Name, and correct model year.
2. Press "Select".
GO TO 4 .
VEHICLE CONFIRMATION
CONSULT
1. Verify VIN or Chassis Number matches the vehicles VIN.
2. Select "Confirm".
GO TO 5 .
INPUT VIN
1. Verify VIN number in dialog box matches vehicles VIN.
2. Select "Confirm".
GO TO 6 .
SYSTEM SELECTION
CONSULT

Select "AIR PRESSURE MONITOR".

GO TO 7 .
OPERATION SELECTION
1. Select "Manual Configuration"
2. Select the DATA PART NO. that matches the low tire pressure warning control unit part number written down in step 1.
3. Select "Next".
GO TO 8 .
WRITE CONFIGURATION
CONSULT
1. Confirm that the correct DATA PART NO. is listed.
2. Select "OK".
GO TO 9 .
CHECKING LOW TIRE PRESSURE WARNING LAMP
1. Turn the ignition switch OFF.
2. Turn the ignition switch ON and check that the low tire pressure warning lamp turns OFF after staying illuminated for approximately two seconds.
  CAUTION: Never start the engine.
Is the inspection result normal?

YES

GO TO 10 .

NO

Perform the "Self Diagnostic Result" in "AIR PRESSURE MONITOR". Refer to CONSULT Function .
PERFORMING SUPPLEMENTARY WORK
1. Perform tire pressure sensor ID registration. Refer to Work Procedure .
2. Perform the self-diagnosis of all systems.
3. Erase self-diagnosis results.
End of work.