LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 170 (Front Axle) >> Removal And Installation >> Front Drive Shaft >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove nut and separate stabilizer connecting rod from lower link. Refer to Exploded View .
  2. Remove shock absorber lower bolt from lower link. Refer to Exploded View .
  3. Remove steering knuckle. Refer to Removal and Installation .
  4. Remove drive shaft from front final drive using Tool (A) and suitable tool (B) by inserting tip of Tool (A) between housing and front final drive.
    GNSJPDIF04Z-004Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION:
    • Do not place drive shaft at an extreme angle when removing drive shaft. Also be careful not to over-extend slide joint of drive shaft.
    • Make sure that the circular clip is attached to the housing.
    • Do not reuse circular clip.
    NOTE:
    • For XD Models, the circular clip is installed on the drive shaft assembly (housing).
    • For Non XD Models, the circular clip is installed in the front drive final drive assembly.

    Tool (A)

    : KV40107500 (-)
  5. Remove front final drive side oil seal. Refer to Removal and Installation (MA235) or Removal and Installation (MA210).
    CAUTION: Do not reuse front final drive side oil seal.
scientia non olet · About LEMON Manuals