LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 169 (Brake System) >> Periodic Maintenance >> Brake Pedal >> Adjustment >> Brake Pedal Height

Brake Pedal Height

WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove instrument lower panel LH. Refer to Removal and Installation .
  2. Disconnect harness connectors from the stop lamp switch and brake pedal position switch (VK56VD) or ASCD cancel switch (Cummins 5.0L).
  3. Turn stop lamp switch and brake pedal position switch (VK56VD) or ASCD cancel switch (Cummins 5.0L) 45° counterclockwise.
  4. Loosen input rod lock nut (1).
    GNSJPFIA03Z-003Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION:
    • Check the height with the floor trim removed.
    • The threaded end of the input rod (2) must project to the inner side (L) of the clevis (3).
  5. Adjust brake pedal height to specification. Refer to Brake Pedal .
  6. Tighten input rod lock nut to specification. Refer to Exploded View .
  7. Turn stop lamp switch and brake pedal position switch (VK56VD) or ASCD cancel switch (Cummins 5.0L) 45° clockwise.
  8. Connect harness connectors to stop lamp switch and brake pedal position switch (VK56VD) or ASCD cancel switch (Cummins 5.0L).
  9. Check brake pedal for smooth operation.
    CAUTION: The stop lamp must turn off when the brake pedal is released.
  10. Install instrument lower panel LH. Refer to Removal and Installation .
scientia non olet · About LEMON Manuals