Toe-In Adjustment

WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.

Adjust the toe-in by varying the length of the steering outer socket.

Loosen the inner socket tie-rod lock nuts.

Adjust the toe using the inner socket.

CAUTION: Always evenly adjust toe using LH and RH inner sockets alternately and adjust the total toe-in to the standard.

XD Models:

Courtesy of NISSAN NORTH AMERICA, INC.

Standard length (L)	: Refer to Steering Linkage - XD Models .
Inner socket length (L1)	: Refer to Steering Linkage - XD Models .
Possible amount of adjustment (L2)	: Refer to Steering Linkage - XD Models .

Non-XD Models:

Courtesy of NISSAN NORTH AMERICA, INC.

Inner socket length (L)

: Refer to Steering Linkage - XD Models .

CAUTION: To prevent damage, hold outer socket across flats using suitable tool while loosening inner socket luck nut.

Tighten the inner socket lock nuts to specification.
- XD Models refer to Exploded View .
- Non-XD Models refer to Exploded View .
  CAUTION:
  - To prevent damage, hold outer socket across flats using suitable tool while tightening inner socket nut.
  - Inspect to make sure no boot deformation during toe-in adjustment. Adjust boot as necessary.