Automatic Drive Positioner (DTC/Circuit Diagnosis)
WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK TELESCOPIC MOTOR POWER SUPPLY
CONSULT
- Turn ignition switch OFF.
- Disconnect telescopic motor.
- Turn the ignition switch ON.
- Perform "TELESCO MOTOR" in "Active Test" mode of "AUTO DRIVE POS".
- Check voltage between telescopic motor harness connector M94 and ground.
(+)
(-)
Condition
Voltage
(Approx.)
Telescopic motor
Connector
Terminal
M94
4
Ground
TELESCOPIC MOTOR
OFF
0 V
FR (forward)
0 V
RR (backward)
Battery voltage
8
OFF
0 V
FR (forward)
Battery voltage
RR (backward)
0 V
Is the inspection result normal?
YES
Replace telescopic motor. Refer to Exploded View .
NO
GO TO STEP 2
- CHECK TELESCOPIC MOTOR CIRCUIT
- Turn ignition switch OFF.
- Disconnect automatic drive positioner control unit.
- Check continuity between automatic drive positioner control unit harness connector M34 and telescopic motor harness connector M94.
Automatic drive positioner control unit
Telescopic motor
Continuity
Connector
Terminal
Connector
Terminal
M34
29
M94
8
Yes
26
4
- Check continuity between automatic drive positioner control unit harness connector M34 and ground.
Automatic drive positioner control unit
Ground
Continuity
Connector
Terminal
M34
29
No
26
Is the inspection result normal?
YES
Replace automatic drive positioner control unit. Refer to Removal and Installation .
NO
Repair or replace harness.