Diagnosis Procedure (With LED rear combination lamps)

1. Turn ignition switch OFF.
2. Disconnect BCM connector.
3. Check voltage between BCM harness connector and ground.

   (+)		(-)	Voltage (V) (Approx.)
   BCM
   Connector	Terminal
   M18	25	Ground	Battery voltage

Is the inspection normal?

YES

GO TO 2 .

NO

Check 10 A fuse [No. 10, located in the fuse block (J/B)].

NO

Check harness for open or short between BCM and fuse.

1. Disconnect stop lamp switch connector.
2. Check voltage between stop lamp switch harness connector and ground.

   (+)		(-)	Voltage (V) (Approx.)
   Stop lamp switch
   Connector	Terminal
   E38	1	Ground	Battery voltage

Is the inspection result normal?

YES

GO TO 3 .

NO

Check harness for open or short between stop lamp switch and fuse.

1. Connect stop lamp switch connector.
2. Check voltage between BCM harness connector and ground.

   (+)		(-)	Condition		Voltage (V) (Approx.)
   BCM
   Connector	Terminal
   M18	27	Ground	Brake pedal	Depressed	Battery voltage
   				Not depressed	0

Is the inspecting result normal?

YES

GO TO 4 .

NO

GO TO 5 .

1. Replace BCM. Refer to Removal and Installation .
2. Perform initialization of BCM and registration of all Intelligent Keys using CONSULT.

Inspection End.

1. Disconnect stop lamp switch connector.
2. Check continuity between stop lamp switch harness connector and BCM harness connector.

   Stop lamp switch		BCM		Continuity
   Connector	Terminal	Connector	Terminal
   E38	2	M18	27	Yes

3. Check continuity between stop lamp switch harness connector and ground.

   Stop lamp switch		Ground	Continuity
   Connector	Terminal
   E38	2		No

Is the inspection result normal?

YES

GO TO 6 .

NO

Repair or replace harness.

Refer to Component Inspection (Stop Lamp Switch) .

Is the inspection result normal?

YES

GO TO 7 .

NO

Replace stop lamp switch. Refer to Exploded View .

Refer to Intermittent Incident .

Inspection End.