Diagnosis Procedure (400W Indicator)

Check AC 120V outlet main switch indicators. Refer to Component Inspection (AC 120V Outlet Main Switch Indicators) .

Is the inspection result normal?

YES

GO TO 2 .

NO

Replace AC 120V outlet main switch.

1. Turn ignition switch ON.
2. Check for voltage between the AC 120V outlet main switch connector M139 and ground.

   AC 120V outlet main switch		Ground	Condition	Voltage (Approx.)
   Connector	Terminal
   M139	6	-	Ignition switch ON	Battery voltage
   			Ignition switch OFF	0V

Is the inspection result normal?

YES

GO TO 3.

NO

Repair or replace the AC 120V outlet main switch indicator power supply circuit.

1. Turn ignition switch OFF.
2. Disconnect AC 120V outlet main switch connector M139 and inverter unit connector B2.
3. Check continuity between AC 120V outlet main switch connector M139 and inverter unit connector B2.

   AC 120V outlet main switch		Inverter unit		Continuity
   Connector	Terminal	Connector	Terminal
   M139	3	B2	3	Yes

Is the inspection result normal?

YES

GO TO 4.

NO

Repair or replace the AC 120V outlet main switch 400W indicator ground circuit.

1. Disconnect A/T shift selector connector M68.
2. Check continuity between A/T shift selector connector M68 and inverter unit connector B2.

   A/T shift selector		Inverter unit		Continuity
   Connector	Terminal	Connector	Terminal
   M68	4	B2	12	Yes

Is the inspection result normal?

YES

Replace inverter unit. Refer to Removal and Installation .

NO

Repair or replace the P range switch signal circuit.