Rear Wheel Alignment Inspection: Adjustment: Camber

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Measure camber of both right and left wheels using a suitable alignment gauge and adjust using following procedure.

Camber

: Refer to Wheel Alignment (Unladen*) .

If camber is not within specification, inspect and replace any damaged or worn rear suspension parts before adjusting.

Turn adjusting bolts in the same direction to calibrate.

Courtesy of NISSAN NORTH AMERICA, INC.

Courtesy of NISSAN NORTH AMERICA, INC.

Tighten adjusting bolt nuts to the specified torque.

Adjusting bolt nuts

: Refer to Exploded View and Exploded View .

CAUTION:

When tightening the nut firmly and checking the torque, use a wrench to prevent the turning of the bolt.
After adjusting camber, be sure to check toe-in.